dealandia
2 days ago Description
- 【Lawn Mower Starter Solenoid Perfect Match】Replaces Murray: 1002004MA, 24285, 424285, 7701100MA; Toro: 111674, 6120-430-0500, 53490009; Wright Mfg: 53490009; Husqvarna: 539101714; MTD: 725-0530, 725-0771, 925-0771; Trombetta Ariens:30577. Compatible with Wright Mfg Stander 32", 36", 42", 48", 52" and 61" Decks, Sentar 48", 52" and 61" Decks, Sports Rapid-Hite 36", 42", 48" and 52" Decks.
- 【Premium Quality Material】435-097 starter solenoid relay is made of tough plastic and durable copper, which allows it to be used in the harshest environmental conditions, protects against dust and water jets, dust & liquid-resistant, anti-rust, and corrosion. High cranking power, reduce startup switch electric current.
- 【Enhanced Performance】Experience the difference with our solenoid's copper wire coil, designed to improve electricity and heat resistance. This translates to a longer lifespan and more efficient performance, reducing the need for frequent replacements.
- 【Versatile Application】This solenoid is versatile enough to fit a variety of lawn and garden tractors with a 4-pole solenoid valve. Whether you're maintaining a small garden or a large estate, this solenoid adapts to your needs. Widely Used on ATV, Utility Vehicle, Snowmobile, Golf Cart, Lawn mower, Garden tractor and more.
- 【How does Starter Solenoid work】When the ignition switch is turned to the start position, the starter solenoid valve engages and distributes battery power to the engine starter. Turn the ignition key to the On position. Find the large terminal posts on the solenoid where the thick red wires connect to the solenoid. Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, you should replace the solenoid.
- 【Install Note】This starter solenoid has the threaded (female) bracket. Write down which wire goes to each terminal before disconnecting old solenoid to facilitate subsequent installation, do not over tighten. If the solenoid fails to work, try loosening the nut slightly; this often resolves the issue.
